TMA Cabinet Contents¶
Pier cabinet TMA-PI-CS-CBT-0101¶
The cabinet is located at level 6 inside the pier. The main purpose of this cabinet is to gather several signals from the pier fixed part and communicate then to the MCS.
Location¶
Contents¶
Azimuth Main Cabinet TMA-AZ-CS-CBT-0001¶
This cabinet is located on the Azimuth platform under one of the deployable platforms. This is the main cabinet for the TMA MCS and contains all the main controllers:
PXIs: TMA, AUX and AXES
Bosch controller + drives (ACW,CCW)
Safety controller, TMA IS
Ethercat I/O module
Ethercat drives line start, cRIO
EIB, one for both AZ and EL
Thermal control
Ethernet switches
Location¶
Contents¶
Door A¶
The top part of this door, which is not visible in the picture below, contains the power supplies for the cabinet as well as the electrical protections for the cabinet.
Door B¶
Door C¶
Azimuth Cabinet 0101 TMA-AZ-CS-CBT-0101¶
This cabinet is located on the Azimuth platform under one of the elevation supports. The main purpose of this cabinet is to gather several signals from the azimuth side in which it’s located and communicate then to the MCS.
Location¶
Contents¶
Elevation Cabinets TMA-EL-CS-CBT-0101 & TMA-EL-CS-CBT-0102¶
These two cabinets are located inside the CST. The main purpose of these cabinets is to gather several signals from the elevation part and communicate then to the MCS.
Location¶
Contents¶
Phase main cabinet TMA-AZ-DR-CBT-0001¶
This is the main cabinet for the drives, which contains the power supply used to charge the capacitor banks. This cabinet is located on the Azimuth platform under one of the deployable platforms.